%; replcomps - our default component file for "repl"
%;
%;
%; First, output a "From" header.
%(void(localmbox))%(void(width))%(putaddr From: )
%;
%; These next lines slurp in lots of addresses for To: and cc:.
%; Use with repl -query or else you may get flooded with addresses!
%; Currently %(decode) should NOT be used on address fields, in case invalid
%; characters are in an address.
%;
%; If no To:/cc:/Fcc: text, we output empty fields for prompter to fill in.
%;
%(lit)%(formataddr{reply-to})\
%(formataddr %<{from}%(void{from})%|%(void{apparently-from})%>)\
%(formataddr{resent-to})\
%(formataddr{prev-resent-to})\
%(formataddr{x-to})\
%(formataddr{apparently-to})\
%(void(width))%(putaddr To: )
%(lit)%(formataddr{to})\
%(formataddr{cc})\
%(formataddr{x-cc})\
%(formataddr{resent-cc})\
%(formataddr{prev-resent-cc})\
%(formataddr(localmbox))\
%(void(width))%(putaddr cc: )
Fcc: %<{fcc}%{fcc}%|+outbox%>
Subject: %<{subject}Re: %(void{subject})%(trim)%(putstr)%>
%;
%; Make References: and In-reply-to: fields for threading.
%; Use (void), (trim) and (putstr) to eat trailing whitespace.
%;
%<{message-id}In-reply-to: %{message-id}\n%>\
%<{message-id}References: \
%<{references}%(void{references})%(trim)%(putstr) %>\
%(void{message-id})%(trim)%(putstr)\n%>\
Comments: In-reply-to \
%<{from}%(void{from})%?(void{apparently-from})%|%(void{sender})%>\
%(trim)%(putstr)\n\
   message dated "%<(nodate{date})%{date}%|%(tws{date})%>."
--------